Category : Vibration control equipment, optical tables > Vibration control equipment

BUYER'S GUIDE

PRINT

BACK

The 6100 Vibration Measurement System is a powerful tool for measurement of rapidly spinning or vibrating targets in high temperature environments up to 1832°F (1000°C). The high temperature functionality of the 6100's CM/DM series probes combines with a conditioned frequency response capability to 128kHz to make the system uniquely suited for any measurement application in which a fast response is required such as blade tip clearance in rotating turbines, turbochargers and jet engines. Other fast moving but non-continuous parts like hydroelectric generators as well as high frequency vibration or modal analysis of continuous targets are other typical applications.

The 6100-SC amplifier provides a digitized output that is acquired by the 6100-DSP card which then performs signal processing that results in a linear output at up to 128kHz. (The 6100-SC can also provide a raw analog output up to 200kHz which can be separately accessed by the user at the module's OBNC port.)

The Model 6100 offers a range of blade tip clearance outputs which are user configurable via the available control software. For high speed vibration applications which cannot utilize the 6100-DSP firmware's temperature compensation, model DM series probes provide improved DC stability over a temperature range to 1100°F (600°C) with maximum operating temperature to 1832°F (1000°C). The high temperature CM and DM Series probes and cables provide operation to 1832°F (1000°C). The outer shields of the CM and DM Series probes are at earth ground potential to prevent electrical shorts and to facilitate ease of installation in tight routing locations.

MODEL 6100 SPECIFICATIONS:
- Typical target size: same as sensor OD or larger
- Frequency response: 2Hz-128kHz (-3dB), conditioned DC-200kHz raw analog optional
- Measurement range: 0.010" to 0.197" (0.254mm - 5.0mm); based on probe size
- Linearity: ±2%/half F.S. with signal conditioning
- Repeatability: ±0.5% F.S.
- Probe Size: 0.156" to 0.750" (3.96mm-19.05mm) OD
- Probe operating environment: Dry, (non-condensing), 32-1832°F (0-1000°C)
- Cable OD: 5U cable, 0.125" (3.18mm): 5U+ cable, 0.137" (3.48mm)
- Cable length: 3 meters max length with earth grounded shield
- Power requirement: +5VDC @350mA; ±15VDC @±50mA provided by 4000 series rack

List of all articles from this supplier

- HPS Series probes - Capacitec
- 2HPB Series industrial wands - Capacitec
- Gap measuring probes: GAPMAN® - Capacitec
- Capacitec® amplifiers and racks for best signal to noise ratio
- Button sensor probe series - Capacitec

List of all articles from this supplier

List of articles in this sub-category

- Standard Wire Rope Isolators
- Electro-Damp® for the control of pneumatic vibration isolation systems
- Type II Faraday Cage
- STACIS® 2100 Active Piezoelectric Vibration Control System
- Mag-NetX Magnetic Field Cancellation System
- Acoustic/Vibration Isolation Chamber

List of all articles in this sub-category Vibration control equipment

List of all articles in this sub-categoryList of all articles in this sub-categoryList of all articles in this sub-category