Category : Machine tools, cutting, molding, machines, precision machining > Thermoforming machines

PRINT

BACK

This small machine can be fit up quickly on all thermoforming machines. Compressed air is the only power supply : a pneumatic jack controls drive and cutting of the selvage. This jack is equiped with pneumatic magnetic detectors and it drives a backward and forward motion.

Synchronization with the machine : a balance weight fitted on a ball slipper guide holds the selvage in position during the power feed on the machine. When the balance weight is going down along the slipper guide, it engages a end of stroke that drive backward and forward motion.

At the foot of the slipper guide an other end of stoke stops the working cycle if the selvage is broken or jammed. The selvage pieces are collected in a cone straight to the a dustbin or by means of centralization in a container.

The use of our system presents several advantages :
Considerable reduction in the buck of selvage waste.
Potential centralization of the waste.
Ease of use for the operator.
Use with flexible and rigid clingfilm.
Pneumatic power supply only.
Easy and quick setting up on all thermoforming machine.

List of all articles from this supplier

- Loading system “Jumbo” – Additif Système

List of all articles from this supplier

List of articles in this sub-category

- Loading system “Jumbo” – Additif Système

List of all articles in this sub-category Thermoforming machines

List of all articles in this sub-categoryList of all articles in this sub-categoryList of all articles in this sub-category