Category : Electric DC motor, linear motor, stepper motor, transmission, drives & control, cylinder, gearbox > Electronic control cards

PRINT

BACK

Digital to Analog Receiver Board

16-Bit Digital to Analog Receiver Board
Industry Standard XY2-100 Interface Protocol
Controls 2 or 3-Axis Scan Heads with One Board
Power Range +/- 15 to 24 Volts DC
Analog Output Ranges +/- 3, 5 or 10 Volts DC
High Quality Monotonic 16-Bit DACs with 1 LSB Differential Linearity Error
NTI's D/A Receiver board can accept industry standard XY2-100 protocol signals from a variety of PC based laser / scanner control cards including NTI's SurfBoard-USB board and SP-Ice PCI card.

The board will accept a range of input power voltages from +/-15 to +/- 24VDC. It can supply X, Y and Z command outputs for analog servo drive inputs. It is configurable to supply +/-3, 5 or 10VDC commands.

It uses high quality components to maintain linearity, high signal to noise and to reduce the effect of thermal changes on the command signal.

List of all articles from this supplier

- Quantum Drive 3000 Servo Amplifiers
- XLR8 2-Axis Scan Head
- Open Frame Scan Heads using QS-7 galvanometer
- HarmonicScan- 15 galvanometer

List of all articles from this supplier

List of articles in this sub-category

- Electronic control card
- Asc system controller for laser devices, sensors, motor drivers
- MI 452A control card for stepper motors
- SIMPA microstep card : microprocessor based indexer

List of all articles in this sub-category Electronic control cards

List of all articles in this sub-categoryList of all articles in this sub-categoryList of all articles in this sub-category