Category : Environmental measurement, test and control equipment > Relative Humidity, Dewpoint meters, humidity transmitters

PRINT

BACK

A simple to use, continuous humidity chamber to meet the test condition required by ISO 6270. The Elcometer 1200/4 is of welded polypropylene tank construction. The PVC cover has two sides, each at an angle of 15 degrees to the horizontal.

The Unit is switched on and water is fed in, through the inlet pipe, under pressure (1-5 bar). Once the water is at the required level, the unit begins to heat and maintain the water to the set temperature (40°C ± 2°C / 104ºF ± 4ºF, and not less than 35°C / 95ºF for ISO 6270).

Up to 20 test panels, 150 x 100 mm (5.9 x 3.9"), are then inserted into the spaces in the PVC cover.

List of all articles from this supplier

- Elcometer 181 Mechanical Concrete Test Hammer
- Elcometer 331² Model B Concrete Covermeter
- Elcometer 106 adhesion tester
- Taber 5750 Linear Abraser

List of all articles from this supplier

List of articles in this sub-category

- Relative humidity sensors
- Dewpoint monitors for relative humidity measurement
- Digital meter for relative humidity measurement
- Hygrostats used for simple control tasks in HVAC applications
- Miniature Humidity Probe from Vaisala
- New Humidity Transmitter from Vaisala

List of all articles in this sub-category Relative Humidity, Dewpoint meters, humidity transmitters

List of all articles in this sub-categoryList of all articles in this sub-categoryList of all articles in this sub-category