Category : Automation, process control equipment, industrial communications > Industrial communications equipment

PRINT

BACK

FlashPro3 offers extremely high performance through the use of USB 2.0 and is high-speed compliant for full use of the 480 Mbps bandwidth. This newest programmer can program ProASIC3E devices in under 30 seconds; even the largest ProASIC3E devices take under two minutes to program. Powered exclusively via USB, FlashPro3 provides a VPUMP voltage of 3.3 V for programming ProASIC3/E and ARM-enabled ProASIC3/E devices. FlashPro3 can connect to any PC with a USB port and can operate either with USB 1.1 (full-speed) or USB 2.0 (both high-speed and full-speed modes). Multiple FlashPro3 programmers may be connected together via USB hubs to enable multiple systems to be programmed in parallel using just one PC with the FlashPro software.
High performance Fusion Flash memory blocks support multiple functions, including state saving of volatile RAM and registers prior to power-down, initialization of RAM and registers at power-up, boot code store, data logging, and configuration data for the analog peripherals.The embedded FlashROM offers another programmable space, supporting use models such as device serialization.

List of all articles from this supplier

- FPGAs designed to assist in system start-up tasks
- ARM7™/CoreMP7 development tool evaluation
- ProASIC3 starter kit
- Flashpro lite programmer

List of all articles from this supplier

List of articles in this sub-category

- 386EX processor at 33 MHz
- PC104 STPC VGA graphic controller
- Master BB multidecoder connectable to different interfaces
- SBC PICMG 1.0 for Intel Pentium
- Brios2 powerful fieldbus-based I/O system
- aX 2-Channel Profibus Card

List of all articles in this sub-category Industrial communications equipment

List of all articles in this sub-categoryList of all articles in this sub-categoryList of all articles in this sub-category