Han-Power® T components

PRINT

BACK

The need to future proof new power distribution systems in industrial plants has essentially the same requirements as those of the data transmission lines i.e. one mechanically robust, well protected pluggable cable line to supply several installed devices.

This simplified power distribution concept can be realised by the use of components from the Han-Power® range.

In particular the Han-Power® T products can fulfil this requirement. For currents up to 16 amps the well-known Han® Q5/0 inserts are integrated into a plastic housing. One connector for power in, one for power out and one “T” connection for supply to the device.

For higher current requirements, up to 40 amps and greater mechanical protection Han Q4/2 inserts are mounted in a zinc die cast case. An additional feature of these inserts is the provision of “finger protection” on the male and female contacts.

Custom preassembled, labelled and 100% tested cables can be built or purchased prior to installation thus minimising assembly time and guaranteeing an error free installed power distribution system.

Article from HARTING

List of all articles from this supplier

- DIN 41612 connector family
- Han® industrial connectors for industrial environments
- M12 microFX component
- Smartcon ethernet switches

List of all articles from this supplier

List of articles in this sub-category

- BCS-SOL5 Photovoltaic Plug Connector
- PH CONNECTORS
- Round plug connectors
- Coaxial Connectors
- Power plug connectors
- Büschel plugs

List of all articles in this sub-category Components

List of all articles in this sub-categoryList of all articles in this sub-categoryList of all articles in this sub-category