Category : Automation, process control equipment, industrial communications > Industrial communications equipment

PRINT

BACK

The Isolated Digital I/O Module adds an additional six +5 to +24 VDC isolated I/O channels to the MicroLYNX. All of the I/O channels can be individually programmed as either inputs or outputs, or as dedicated (limit, home, etc.) or general purpose.

When used as inputs, these I/O channels have seven programmable digital filter settings ranging from 215 Hz to 27.5 kHz. As outputs, each channel can sink up to 350 mA. The I/O is isolated from the power supply ground.

A 7.5kOhm switch selectable pull-up resistor is provided for each I/O channel. The six I/O channels may be pulled up to either the internal +5 VDC supply or an external voltage provided by the user. Protection circuitry includes over temperature, short circuit and inductive current clamp.

List of all articles from this supplier

- OSC-462H Analog Speed Control Interface Board
- Hybrid Stepping Motors
- MDrive14 Planetary Gearbox
- IM481H PLUS microstepping driver

List of all articles from this supplier

List of articles in this sub-category

- 386EX processor at 33 MHz
- PC104 STPC VGA graphic controller
- Master BB multidecoder connectable to different interfaces
- SBC PICMG 1.0 for Intel Pentium
- Brios2 powerful fieldbus-based I/O system
- aX 2-Channel Profibus Card

List of all articles in this sub-category Industrial communications equipment

List of all articles in this sub-categoryList of all articles in this sub-categoryList of all articles in this sub-category