Category : Sensors, probes, transducers > Gauging probes, digital lever probes

PRINT

BACK

The electronic gauge Monocote enables to check dimensions from 2 or 4 inductive, digital probes or linear encoders. Three indicator lights or an analogical diode display indicate the dimension position compared with tolerance limits.

DYNAMIC MEASUREMENTS:
The electronic gauge Monocote is fitted with digital memories which record the dimension evolution during a dynamic measurement (ovality, flatness, eccentricity, etc.) It is therefore possible to display the maximum, minimum, maximum-minimum and average value of a dimension.

PROBES:
It is possible to simultaneously connect maximum 4 of the following different types of probes:
- 2 standard inductive probes
- 4 digital probes (Orbit Network)
- 4 linear encoders (Orbit Network).
The 4 probes are each given a coefficient and can be combined to measure one dimension.

SPECIFICATIONS:

- 8 measurement configurations (8 dimensions)
- Static and dynamic measurements
- Numerous interfacing possibilities
- 46 functions programmable by the operator
- Inductive probes
- Digital probes (Orbit Network)
- Linear encoders (Orbit Network)
- Modbus and Jbus compatible
- Reliable and easy to use

FUNCTIONS:
Many functions and measurement modes can be selected by means of the keyboard or by remote control through the RS 232 / RS 485 port:
- Nominal dimension
- Tolerance limits
- Dimension of the master piece (reference piece)
- Calibration mode and calibration checking
- Storage of over/under tolerance limits
- Display of individual probes
- Limitation of the maximum measuring range of different probes
- Measurement mode (maxi-mini, maxi, mini, average, median)
- Relative display compared with an original position
- Display resolution (2,3,4 decimals)
- Metric or imperial measurements (mm or inches)
- Temporary measurement stop
- Selection between 8 measurement configurations (8 dimensions) with automatic or non automatic change.
THE RS 232 or RS 485 INTERFACE
A RS 232 or RS 485 serial port enables the user to read the measured values and to download all the parameters which will be used to operate the Monocote.

THE OPTIONS:
Bargraph display: The dimension position compared with tolerances is indicated on a 30 LED analog display.
Relay board: Two relays give the state of the tolerance indicator lights. The functions can be selected by remote control during dynamic measurements thanks to 4 optocoupled inputs.
Multi-functional board: Two relays give the state of the tolerance indicator lights. Two analog outputs give a 0-10 Volts and 4-20 mA signal which indicates the dimension position compared with two programmable thresholds. The functions can be selected by remote control during dynamic measurements thanks to 4 optocoupled inputs. 1 to 8 programmable sorting classes can be defined with 8 optocoupled outputs.

List of all articles from this supplier

- Orbit network: A high speed bus for probes - Metro
- Datamux : Multiplexers for 8 measuring instruments – Metro
- DPC 20 Manometer designed to measure the pressure of aerosol cans
- Inductive probes : A wide analogic probes range - Metro

List of all articles from this supplier

List of articles in this sub-category

- QUICK SNAP™: retoolable manual snap to gauge o.d. of cylindrical parts - Testar
- QUICK BLOCK™ : universal measuring armsets - Testar
- M1 C: manual bore gauge with hbt transducers - Testar
- New Digital Lever Probe by Solartron
- Rugged, Digital Mini Probe Reflects Industry's Needs
- Block Gauge

List of all articles in this sub-category Gauging probes, digital lever probes

List of all articles in this sub-categoryList of all articles in this sub-categoryList of all articles in this sub-category