Category : Sensors, probes, transducers > Nanosensors

PRINT

BACK

Neuchâtel, January 27, 2006. The new NANOSENSORS™ Q30K-Plus AFM tip with a very high Q-factor and an enhanced signal to noise ratio for UHV applications was introduced today.

Based on the well-known PointProbe® Plus AFM probe NANOSENSORS™ has developed the Q30K-Plus SPM-probe series especially for UHV applications. For high sensitivity and a good signal to noise ratio the new probes are featuring a Q-factor of over 30,000 (up to 50,000) under UHV conditions and a high reflectivity (even at wavelength of over 800nm).

In addition to the enhanced Q-factor and the optimized signal to noise ratio the Q30K-Plus series offers all features of the PointProbe® plus series like a minimized variation in tip shape and a typical tip radius of less than 7nm.
The Q30K-Plus™ AFM probe is available in the following types and package sizes:
PPP-QNCHR-10 for Non-Contact Mode/Tapping Mode™

Typical Values:
- Force Constant = 42 N/m
- Resonance Frequency = 330 kHz
- Cantilever Length = 125 µm
- Cantilever Width = 30 µm
- Quality Factor = 30000
- Packages of 10 probes
- PPP-QFMR-10 for Force Modulation Mode,

Typical Values:
- Force constant = 2.8 N/m
- Resonance frequency = 75 kHz
- Cantilever length = 225 µm
- Cantilever width = 28 µm
- Quality Factor = 30000
- Packages of 10 probes

List of all articles from this supplier

- NanoWorld™ announces Pyrex-Nitride AFM Probe
- NANOSENSORS™ announces new high-Q AFM probe
- New PointProbe® Plus AFM Probe from NANOSENSORS™
- NanoWorld™ Introduces Hybrid-Nitride AFM Probe

List of all articles from this supplier

List of articles in this sub-category

List of all articles in this sub-category Nanosensors

List of all articles in this sub-categoryList of all articles in this sub-categoryList of all articles in this sub-category