Category : Sensors, probes, transducers > Switches

PRINT

BACK

In EN 1088 legislators require that manipulation protection on safety devices be guaranteed. If non-coded sensors are used, designers are required to guarantee this through concealed installation.
With safety switches PSENcode, the highest protection against manipulation is built into the switch:
The safety switch and actuator work together in such a way that the enable from the safety device is only triggered if the actuating element is within the switch's response range and the code number on the actuator matches that of the switch. Two versions of this key lock principle are available: for use with any PSEN actuator or with an actuator that is uniquely assigned to the PSENcode

List of all articles from this supplier

- Non-contact safety switches
- Muting lamps
- PMI diagnostic and graphics systems
- Three-phase voltage monitoring

List of all articles from this supplier

List of articles in this sub-category

- Safety Switch without Interlocking NP
- Proximity switches
- 0732 electrolytic switch
- M300 slipswitch speed switch
- Whirligig & magcon speed switches
- Non-contact safety switches

List of all articles in this sub-category Switches

List of all articles in this sub-categoryList of all articles in this sub-categoryList of all articles in this sub-category