Category : Automation, process control equipment, industrial communications > Industrial communications equipment

BUYER'S GUIDE

PRINT

BACK

Prototype card PROTO-AT provides means to develop custom cards for use in ISA bus computers. The card buffers all address lines, data lines, and some of the control signals. It also provides address decoding for I/O addresses 000 through 3FF and for memory addresses 00000 through FF000 and allows set up of the selected address block size.
The card provides approximately 35 square inches of breadboard area for custom circuit development. This breadboard area contains over 2600 plated-through holes for easy component soldering. The holes are 0.035 inches in diameter with 0.100 inches spacing. The breadboard area is surrounded by heavy buses for ground and +5 VDC power.

List of all articles from this supplier

- WDG-2S- Dual-Port Isolated RS-422/485
- COM485/8 serial communications card
- Isolated digital input card
- AD12-16/16F analog and digital I/O card

List of all articles from this supplier

List of articles in this sub-category

- 386EX processor at 33 MHz
- PC104 STPC VGA graphic controller
- Master BB multidecoder connectable to different interfaces
- SBC PICMG 1.0 for Intel Pentium
- Brios2 powerful fieldbus-based I/O system
- aX 2-Channel Profibus Card

List of all articles in this sub-category Industrial communications equipment

List of all articles in this sub-categoryList of all articles in this sub-categoryList of all articles in this sub-category