Category : Electrical and electronic equipment & instrumentations > Electrical protection devices, fuses

BUYER'S GUIDE

PRINT

BACK

Partial Discharge (PD) testing is a proven diagnostic method for non-destructive cable testing for
many years. Using partial discharge measurement with source localisation, direct allocation of partial discharge activity on cable segments, joints or cable terminations is enabled.
The portable partial discharge location system is designed as a complement for BAUR VLF truesinus® generators with output voltage up to 40 kVrms.

Features:
o PD level measurement
o PD source localisation
o Display of PD activity over the cable length
o Menu guided control software (Windows 2000)
o High noise suppression completely isolated from mains supply
o On site PD calibration provided according to IEC 60270
o Use with external HV source up to 40 kVrms truesinus (VLF 20, VLF 28)

List of all articles from this supplier

- DTL system designed for measuring the aging factor in insulating fluids
- PGK 25 High Voltage Test Set
- Transcable Cable test van
- KFM 3000 suitable for determination of water in isolating liquids

List of all articles from this supplier

List of articles in this sub-category

- FS725 Benchtop Rubidium Frequency Standard
- SIM900 flexible platform
- SLD dual input modular electronic loads
- TrueWave ideal for testing electronic equipment
- 2200 and 5000A isolators
- 88000 Series ATS-620 Array Test System

List of all articles in this sub-category Electrical protection devices, fuses

List of all articles in this sub-categoryList of all articles in this sub-categoryList of all articles in this sub-category