Category : Electrical and electronic equipment & instrumentations > Components

PRINT

BACK

These probes are assembled with RTD's on which leads are welded These RTD's have a low ohmic value
(see corresponding heading) and the lead length presents a resistance in serie with the sensitive element which harms the measurement accuracy.

To avoid such reaction, 3 or 4 leads are used so as to separate the measurements leads from the feeding leads, thus, the measurement leads will not be supporting a current and their own resistance will be negligible.
Probes with Platinum or Nickel sensors are connected to electronics for measurement, data or automation by means of a 4-20 milli Amp. Transmitter (the most suitable solution)or a 0-10 V. or 0-5 V. voltage transmitter.

It is strongly advised to place the transmitter as closed as possible from the sensor to avoid RFI in the leads

List of all articles from this supplier

- Thermal Protections
- Thermocouple Probes
- Thermistors Probes
- NTC Thermistors

List of all articles from this supplier

List of articles in this sub-category

- BCS-SOL5 Photovoltaic Plug Connector
- PH CONNECTORS
- Round plug connectors
- Coaxial Connectors
- Power plug connectors
- Büschel plugs

List of all articles in this sub-category Components

List of all articles in this sub-categoryList of all articles in this sub-categoryList of all articles in this sub-category