Category : Instrumentations for fluid management, control and transfer (gas and liquids) > Flow control

PRINT

BACK

Verify water flow rate (GPM/lpm) meets manufacturer's minimum specification
Make sure flow sensor is plugged in.
Turn the water on. Verify the wheel is spinning and there are no foreign objects obstructing the water flow.
The laser should not have any back pressure on the drain line, this will prevent proper cooling of the laser and the flow sensor may no function.
Measure the voltage across flow wheels terminals on the back of the sensor, this should be a minimum of 70 mv AC with water running through the laser
The above procedure will determine if the flow switch is faulty. Further, if the flow switch is intermittent this would indicate a bad sensor coil. Most older flow sensors must be replaced in its entirety. When replacing a flow sensor, we recommend using the brass housing series. It is a bit more expensive, but it is not prone to cracking and the sensor coil is replaceable

List of all articles from this supplier

- Air cooled laser
- Flow Cytometry
- Remanufacture Primer
- KLA/TENCOR Wafer

List of all articles from this supplier

List of articles in this sub-category

- Trolleys Suitable for fast transport
- Optimal material flows
- Flow Measurement System
- Flowmeter with float principle
- Optimeter flow meter designed to measure the water flow rate
- FFP Series Paddle Wheel Flow Meters

List of all articles in this sub-category Flow control

List of all articles in this sub-categoryList of all articles in this sub-categoryList of all articles in this sub-category