Category : Machine tools, cutting, molding, machines, precision machining > Precision metal parts and tooling solutions

PRINT

BACK

Rework stencils which ensure accurate and repeatable printed results, for single component footprints such as QFP's, PLCC's, BGA's, µBGA's and surface-mount connectors, are now available from Tecan, along with a range of associated accessories.

Precision stencils mimic the footprint and aperture sizes corresponding to both the device requirements and the original stencil used in production. In combination with a rework station, alignment is simple, resulting in a controlled 'right first time' process.

Offering optimum reliability and consistent printed results, the rework stencils are both strong and rigid to ensure positive gasketting with the PCB surface. The compact designs include minimal stencil projection beyond the image to be printed thereby enabling use in all situations, especially high-density component areas. Accurately folded edges and run-on / run-off areas ensure effective paste roll and containment without causing interference to other components on the populated PCB.

In addition to the provision of specialised rework stencils, the company provides personalised help and advice to overcome the most demanding needs. Other rework solutions include dip transfer plates, BGA re-balling stencils, direct component printing stencils and reflow reflector shields.

Dip transfer plates enable the accurate application of precise flux volumes to the lower quartile of the solder balls of Ball Grid Array (BGA) components, thereby eliminating excessive flux contamination on the underside of the reflowed component.

BGA re-balling stencils offer advantages in two areas. Firstly, to ensure the precise registration of new solder spheres onto pre-printed flux deposits, and secondly, in the form of the thicker stencils necessary for printing solder paste onto the BGA itself to create new solder sphere terminations.

For depositing paste onto the pads of the BGA device itself, where the printed device will be picked and placed onto the printed circuit board (PCB) and subsequently reflowed, direct component printing stencils are used.

During reflow, the company's reflow reflector shields provide critical protection for heat sensitive components on densely populated PCBs, where an adjacent device is to be reworked / reflowed. The reflow shields are custom-made to fit over leaded components such as connectors, crystal oscillators, switches, inductors and capacitors, during reflow. In the reflow oven the shield reflects heat energy, thereby preventing damage to the component body, while simultaneously allowing conducted heat from the bottom of the PCB to reflow the solder paste effectively, ensuring a good joint every time.

List of all articles from this supplier

- Grids for mass spectrometers, electron microscopes
- Tecan releases four software packages that unite to integrate your data
- Board-level RFI screening technology cuts assembly time - by 80%
- Unique new QC tool qualifies and quantifies Tecan laser scanners
- PEF sieves ensure 100% of material is accounted for
- TECAN introduces Multi-level evaporation masks are robust and accurate

List of all articles from this supplier

List of articles in this sub-category

- Tecan releases four software packages that unite to integrate your data
- Board-level RFI screening technology cuts assembly time - by 80%
- PEF sieves ensure 100% of material is accounted for
- TECAN introduces Multi-level evaporation masks are robust and accurate
- Multi-level stencils optimise post-print rework costs
- Cost-effective process delivers burr and stress free metal parts

List of all articles in this sub-category Precision metal parts and tooling solutions

List of all articles in this sub-categoryList of all articles in this sub-categoryList of all articles in this sub-category