Category : Environmental measurement, test and control equipment > Moisture analyzers

BUYER'S GUIDE

PRINT

BACK

Water in contact with some liquids can allow the stream to become turbid, thus eliminating the use of spectroscopic-based analyzers. Leaks from heat exchangers can cause water to enter liquid streams and possibly react with the liquids. Moisture in contact with chlorinated solvents and other chemicals can form acids, allowing possible corrosion of piping and equipment. Since most analyzers only detect water up to 2000 ppm, GOW-MAC designed an analyzer that tracks the moisture content up to the percent level. This information allows plant personnel to determine if they should shut down an operation immediately due to excessively high water levels, or wait until scheduled repairs can be implemented. The cost of reworking or replacing products and damaged equipment can be significant. The Series 7500 ensures that you are aware of the water content in your liquid streams at all times.

key features:

-Detects H2O from low ppm to % concentration
-Detects H2O levels in turbid samples
-Fast initial response to moisture levels
-Fast recovery from high moisture levels
-High sensitivity, with high level of repeatability
-Cell designed for high flow rates, preventing reformation of water from O2 and H2
-Thermostatically controlled cabinet
-Stainless steel or corrosion resistant materials

List of all articles from this supplier

- Gas Leak Detector
- Model 75-900 oxygen trap
- Model 24-600 temperature regulated DID
- Series 600 temperature programmable gas chromatograph

List of all articles from this supplier

List of articles in this sub-category

- Moistrex MX5000 Moisture Analyser

List of all articles in this sub-category Moisture analyzers

List of all articles in this sub-categoryList of all articles in this sub-categoryList of all articles in this sub-category