Category : Environmental measurement, test and control equipment > Leak detection systems

BUYER'S GUIDE

PRINT

BACK

The TTSIM-2 Sensor Interface Module monitors up to 500 feet (150 m) of TraceTek sensing cable. With its internal alarm relay, front panel LED status indicators and LCD leak location display, the TTSIM-2 can be used as a stand-alone leak detection alarm or it can be connected to a TraceTek SIM network, Distributed Control System or Building Management System. When liquid is detected, the TTSIM-2 activates its alarm relay and display the leak location on the front panel LCD. The TTSIM-2 can also provide accurate leak location information to a host system using standard MODBUS, Opto-22, or Johnson Controls Metasys protocol. Although massive sensor cable systems are possible with networked TTSIM-2’s, their low cost makes it economical to build very robust systems with many small independent sensing cable segments. No field calibration is required other than a map to show where the sensor cable has been installed.

List of all articles from this supplier

- Harnesses for gas turbines
- Gas Turbine Sensors
- Thermocouple Cables

List of all articles from this supplier

List of articles in this sub-category

- BigEZ Multi-Dose Dye Injection System
- TP-9370 Marksman Ultrasonic Diagnostic Tool
- Tracer-Charge for leak detection
- TP-9360 Pro-Alert leak detector
- Customised machine for leak test
- T1VE-S leak tester

List of all articles in this sub-category Leak detection systems

List of all articles in this sub-categoryList of all articles in this sub-categoryList of all articles in this sub-category