|
Category : General industrial equipment, special machines > Mixing and dispersing systems
Transport and dissolving system
When mixing powder into a liquid, you are familiar with the following problems:
- Dust
- Contamination of the working area
- Dirty powder transporting systems, that are difficult
to clean
- Detrimental to health
- Exhaust systems and filters have to be installed
- Loss of powder (during filling, in the filter of exhaust
systems, remnants in the bags
- Partial wetted crusts at the wall of the vessel and
mixing shaft
- Agglomerates in the product
These problems can be avoided by directly inducting the granulate or the powder into the liquid and immediately wet and disperse it when the product comes in contact with the liquid.
No vacuum vessels or additional vacuum pumps are required. The induction vacuum is directly created in a highly accelerated liquid stream. The vacuum fluidises the powder and brings it finely distributed in contact with the liquid. Simultaneously to the wetting, the product is dispersed, no lumps and/or agglomerates can build up. Powdery materials may be inducted dust-free and without any loss of powder from any type of powder container.
The system that was used to realise this idea became known under the name TDS-system (Transport- and Dissolving System).
List of all articles from this supplier
- Inline high speed disperser
- Batch high speed dispersing
- Ystral dispermix mixer disperser
- JetStream Mixer
List of all articles from this supplier
List of articles in this sub-category
- Inline high speed disperser
- Batch high speed dispersing
- Ystral dispermix mixer disperser
- JetStream Mixer
List
of all articles in this sub-category Mixing and dispersing systems
List of all articles in this sub-categoryList of all articles in this sub-categoryList of all articles in this sub-category
|
